Charging the Patient Simulator
Connect the Patient Simulator to the external power supply.
Battery and power status can be viewed on the Patient Simulator’s power panel (blinking yellow LED) and the Simulator Status window in LLEAP.
CAUTIONS
After the Patient Simulator is turned off, wait 20 seconds before restarting or the Patient Simulator may not function properly.
Never store a fully charged battery for longer than a month.
Only use the MamaAnne external power supply and batteries.
The external power supply is for indoor use only.
NOTES
On approximately every 30th charge cycle, drain the battery completely before recharging. To drain the battery, run the Patient Simulator until automatic shutdown.
Refer to the Important Product Information for further information on the battery.
CPU Module (Component of simulator)
CAUTIONS
Do not interrupt or power down the system during a software update.
The device for operation in the band 5150- 5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems.
The maximum antenna gain permitted for devices in the bands 5250-5350 MHz and 5470-5725 MHz shall comply with the e.i.r.p. limit.
The maximum antenna gain permitted for devices in the band 5725-5825 MHz shall comply with the e.i.r.p. limits specified for point-to-point and non point-to-point operation as appropriate.
The worst-case tilt angle(s) necessary to remain compliant with the e.i.r.p. elevation mask requirement set forth in Section 6.2.2(3) shall be clearly indicated.
Users should also be advised that high-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices.
External Power
WARNINGS
Only connect the Patient Simulator to a Laerdal approved external power supply dedicated to use on MamaAnne.
Do not use the Patient Simulator in close proximity to real patients when it is connected to the external power supply.
The Patient Simulator should be connected to an electrical outlet that is properly grounded.
The external power supply is for indoor use only.
Use only the external power supply supplied with the product.
Battery
This Patient Simulator is operated on a Li-ion battery. Li-ion batteries should be recycled or disposed of in accordance with local regulations.
Warnings
Only use the designated Laerdal approved battery in the Patient Simulator.
Do not use the Laerdal Li-ion Battery for other purposes than specified.
Do not use the battery in temperatures above what is specified in the Specification table.
Do not heat, incinerate, or crush the battery.
Do not short circuit the battery contact.
Do not immerse the battery in water.
Inserting and connecting the battery incorrectly, short circuiting or exposure to fluids pose an explosion hazard.
Do not mistreat, disassemble or attempt to repair the battery.
Do not use the battery if it is visibly damaged, malfunctions or appears to leak electrolyte.
Take extreme care to avoid direct contact with electrolyte, hot or smoking parts. In case of the above, disconnect and remove the battery when it is judged safe to do so.